#LM 741 HOW TO#

The square wave output is still determined by the saturation of the opamp as before, an opamp with rail to rail output will get very close to the supply rails. The second stage is configured as an integrator and will produce a triangular wave with linear slopes. The first stage is arranged as a schmitt trigger to detect when the output of the second stage reaches voltages determined by resistors R1 and R2. It still uses two opamps and only needs one capacitor to set the timing. This configuration should give better results: The 741 os a very ancient opamp and is not as good as more modern ones - as Peter mentioned the output cannot get closer than ~2.5v to the rail. You can use something in the range 10k-100k.ģ) The actual amplitude of the output will be limited by the opamp. Always store and use the IC under -55 centigrade and +125 centigrade.1) The second stage will generate an exponential rather than a triangle.Ģ) The resistor values for feedback on the second stage are much too low - the amplitude may be limited by the output current capability of the 741. Do not apply more than ☒2V to the chip and the minimum operating voltage should be ☑0V.For good performance always decouple power supplies by using a 0.1uF capacitor and place it as near as possible to the IC in your circuit. To safely run lm741 IC for long term in your projects / devices do not apply load more than 500mW. To get long term good performance from ICs it is suggested to always stays under its maximum ratings.

#LM 741 HOW TO#

How to Get Good and Stable Long Term Performance from this IC: The power supply of this circuit is also 9V. Now the LED will become activated when the level or darkness on the surface of the LDR will reach at the preset level set by the 120K variable resistor in the circuit. The operating voltage of the is 9V DC.Īs in the above circuit the lm741 is also used in this dark sensor circuit in astable multivibrator mode but this time, for detecting darkness the middle pin of the variable resistor is connected with pin three / non inverting input of the IC. The LED will become activate when the light level on the LDR will reach the preset level set by the 120K variable resistor. The circuit is using an LDR sensor to sense light. the 120K variable resistor is used to adjust the sensitivity or activation point of the LED. This light sensor circuit shown below is using LM741 IC as a multivibrator in the circuit. This first circuit is a light sensor and the second is dark sensor circuit. There are two circuits show below using the LM741 IC. Replacement / Equivalent / Other Part Numbers: It can also be used in summing amplifiersĪctive filters can be built using this IC input and output, this features saves the internal circuitry of the IC from damage by overload. Moreover the IC is also overload protected from both sides i.e. Its feature like high gain, low current consumption and wide supply voltage makes it ideal to use in battery operated circuits. The IC can be used in wide range of analog projects. The number of transistors used in the internal circuitry of the IC is 20.

The IC is available in many different packages. LM741 is an operational amplifier IC packed with many features. This pin is used to get rid of offset voltage & balance the input voltage.

The operated current is from 1.7 to 2.8mA.

The internal circuitry is also latch up protected.

It is direct replacement for lm201, MC1439, 748.

It can be operated with both single and dual supply.

Can be operated from wide supply range.

The internal circuitry is designed to stay stable at different temperatures.

The IC also contains protection circuitry for short circuit.

This IC contains overload protection circuitry at the input & output.

Advertisements LM741 IC Features / Technical Specifications:

Lm 741